Allsop Redmond Mouse Pad

Rate this product

Have an opinion on this product that you would like to share? If so, please take a few moments to submit your rating and review.

Perfect for high performance gaming mice
Review posted on Aug 10, 2007
29 out of 40 found this review helpful

I own a Razer Copperhead mouse and I had gone through several mouse pads and they all seemed to give poor tracking for the mouse. Everything just made the mouse move too slowly. With this mouse pad I am getting excellent tracking. This pad gives absolutely perfect glide for the high demands of a gaming mouse. No delays from the mouse pad, thus allowing me to get full use of the features of my mouse. If you are a gamer and have a high quality gaming mouse where you want exact precision I highly suggest this mouse pad

Was this review helpful to you?   Yes / No

doesn't slip
Reviewer: heeros1 from VA on Oct 30, 2008
2 out of 2 found this review helpful

I like the idea of a heavy mouse pad a lot, it doesn't slip, and I haven't had a problem with the underside being sticky, or hard to remove. I've had it in the same position for the past year, and I can still lift it off my desk without a problem. The topside of the pad is noticeably warn by using it daily for several hours, and at some point I noticed that the parts that are warn were problematic for my MX1000 to track on, however, my MX Revolution hasn't had a problem yet. when it was new I didn't havea problem with any of my mice (Logitech MX series mice).

The only problem I've noticed is that after several months of usage the layers of the metal border start to come off from rubbing against my wrist and the moisture from my skin. Right now the front of it has turned to an ugly brown with lighter borders and spotty green as the copper oxidized. (a friend of mine has the same pad, and his is showing this as well.

Was this review helpful to you?   Yes / No

Good for laser, bad for desks
Review posted on Apr 5, 2008
4 out of 6 found this review helpful

After using the mouspad for several months and noticing the rubber foam bottom comes off very easy (the sticky glue never dries) I finally upgraded to a new one. The only problem, the rubber/foam bottom was stuck to my desk! The residue was impossible toremove without damaging the clear coat on the desk.

The top works fine for laser mice, but again, I wouldn't recommend this pad because of the horrible, sticky design of the bottom.

Was this review helpful to you?   Yes / No